Rocket Trophy Ridge

Rocket Aeroheads Meat Seeker : The Top Quality Product

I shot Rockets when they came out and had to find how they work in xbow. I have shot Rocket Steel head 100's from my Parker Terminator & Cyclone at 350 fps. Rocket suggests using two bands on 300fps, however I tested with one band. They worked fine, no early opening of blades. One problem that I note was unless blades were straight, that is new, arrow will shoot off as blades angle causes a head to spin arrow, hence steering it. This was just noticed when blades bent going in my Morrells broad head target. After bending it back about three times, blades will break, therefore requiring blade replacement for the continued testing. In case, you straighten these blades before each shot. You may want to try with Slick Tricks since they fly better, tighter groups & cut bigger hole than advertised size. I switch to the Slick Tricks in xbow. Best part is that ST are very tough like Steel heads, and have replaceable blades, and are solid steel, they cost very less! I am sold on ST for xbow, and will use them on vertical.

I have got my dad 125-grain Strick-nines for his cross bow, and he is shooting 382-fps with Barnett Predator & we put 2 rubber bands on broad head & they shoot very fine. He shot 2 bucks with them, tip and 1 blade broke-off on a head but we think it happened after they went threw deer & in ground and next one hit deer's quartering away right at the back of his shoulder & exited right threw an opposite shoulder blade & blades where bent "however what head wouldn't be " but instead that head looked good.

Think they are as well called Meat Seeker and Power Piston. Somebody gave me 3 new ones in package. Package says "Piston Point Broad heads" however they look very much like a Trophy Ridge Undertaker or Meet Seeker broad heads. I have been fixed blade shooter, however these look very good, and looks are deceiving.

Piston Point Broad heads are very uniquely engineered with aerodynamic front tip & rear cylinder, which are connected by solid, and stainless steel piston. When in the flight razor sharp blades straddle rear cylinder, enabling broad head to fly through air like field tip. When tip touches this target, rear cylinder thrusts all shafts inertia forward, and throwing blades completely open & locked in position. Every broad head has 3 blades with thickness of .039 & 1.5" cutting diameter.

Can Piston Point Broad heads used again after shooting animal?
Absolutely! When harvesting the animal, we suggest that you clean blood, hair, and other debris from broad head & replace blades to insure you have razor sharp blades for next hunt.

Do the flex bands break after every shot?
Definitely not! The Piston Point Broad heads are designed with small notch on backside of the blades, making it very easy for flex bands to roll it back on shaft without any breaking. We as well include nine flex bands in each retail pack is one is lost and broken after an extensive shooting in targets.

About the Author

Rocket Aeroheads Meat Seeker
has 3 blades with thickness of .039 & 1.5" cutting diameter available at http://shop.eaglearchery.com